|
|
|
#1
04-27-2015, 08:18 AM
|
||||
|
||||
|
Vertical centering on a Zenith F2740R?
Picked up this nice restored '61 Zenith F2740R yesterday, 16F23 chassis. I just love love love love 21" and 23" Zenith consoles
 Anyway, I got it dialed in nicely with the exception of the vertical centering. It's just a little bit too low. Anyone know where the control is for that offhand? Needless to say I don't have the Sams, but I figured someone here might know offhand.....
__________________
"Restoring a tube TV is like going to war. A color one is like a land war in Asia." 
|
|
#2
04-27-2015, 08:27 AM
|
||||
|
||||
|
There should be centering rings on the back of the Yoke I think.
|
|
#4
04-27-2015, 12:33 PM
|
||||
|
||||
|
Put it under your bench like I did with mine. Its a great keeper - starfish knob
__________________
"When resistors increase in value, they're worthless" -Dave G
|
|
#5
04-27-2015, 05:28 PM
|
||||
|
||||
|
No way, I'm going to use the snot out of this set
But with the GE 801 I just got yesterday things are starting to look a little tight once again. The ever-present battle we TV guys face.
__________________
"Restoring a tube TV is like going to war. A color one is like a land war in Asia."
|
| Audiokarma |
|
#7
04-27-2015, 07:14 PM
|
||||
|
||||
|
Glad that helped, I wasn't 100% sure the Zenith had the rings but most B&W sets of that era did, except the Predictas, they have those little knobs on the yoke, probably does the same thing though.
|
|
#8
04-28-2015, 10:09 PM
|
||||
|
||||
|
That Zenith set is very close to a set I would like to have. My folks had a 21" or 23" table model that I think was a year or two earlier. Metal cabinet. VHF only.
I don't know the model number.
|
 |
|
|
Linear Mode
