|
|
|
#1
10-05-2012, 01:21 PM
|
||||
|
||||
|
Scratches in CRT face
Is there a process or any recommended way to try to remove scratches from the face of a CRT? I would imagine that you could only be somewhat successful depending on how deep they are of course but anything to minimize what's there is better than wasting a good tube.
My primary concern is with the non-bonded glass tubes, but I'd be interested on the newer safety glass types also. Last edited by marty59; 10-06-2012 at 08:59 AM. Reason: make my post more clear 
|
|
|
Threaded Mode