Is my Philco 49-1240 missing a tuner cover?

[Phil Nelson]

Should there be a metal cover over the tuner to keep dust out?

Phil Nelson
Phil's Old Radios
http://antiqueradio.org/index.html

[Eric H]

None of mine have one.

[bandersen]

No cover on mine either.

[Phil Nelson]

OK, I'll take your word for it. There are holes in those little triangular tabs, as if something would be attached there, but possibly that part was used in more than one chassis.

Phil Nelson

[Big Dave]

These tuners did not have covers. As I understand, Philco offered a fine tuning accessory that may have used the tabs in the front.

[Einar72]

I spy a bumblebee!

My 49-1040 has none, either...

[Eric H]

That tuner was used in several chassis, sometimes it mounted on the underside or the opposite side and that's what those holes are for I think.

A little dirt keeps the contacts polished up!

[Eric H]

I'm sure you already know that Renovated Radios sells new corner mounts for the Philcos right?

http://www.renovatedradios.com/parts.html

[Phil Nelson]

Ah, the corner mounts. A couple of mine are cracked and losing stray bits. I was scheming to glue them together in hopes of getting a few more miles out of 'em, but maybe I will splurge and get those repros.

Phil Nelson

[ChrisW6ATV]

Originally Posted by Einar72

I spy a bumblebee!

It took me a minute, but I see it too, Einar.

[Phil Nelson]

Hey, you should have seen the underside -- bumblebees galore! Never fear, they have all suffered the true death.

Phil Nelson

[bandersen]

Originally Posted by Phil Nelson

Ah, the corner mounts. A couple of mine are cracked and losing stray bits. I was scheming to glue them together in hopes of getting a few more miles out of 'em, but maybe I will splurge and get those repros.

Phil Nelson

If you do get the repro. mounts, make sure you reuse the metal inserts. They work fine in my Philco radios but this chassis is a lot heavier - especially around the transformer. Those inserts give the mounts a little more strength.

[M3-SRT8]

Bumblebees...

My Philco 48-1001 had a ga-zillion of them. I replaced them all, of course, along with all the Electrolytics AND the 7 or 8 Micas. Also, I replaced all the CandiOhm Wirewounds. It sprang immediately to full life after that. Just minor tweaking to optimize it's performance. Thank God, as it is a very complex chassis. I would have hated to troubleshoot or align the set.

Result? One of my best performing 10BP4 based TV Sets. Great Picture, mediocre sound. The Tuner is a weak spot of the design, as it wanders a bit, and you have to occasionally tweak the Tuning Oscillator. But the Video performance is superb. Great depth of field, black levels, and contrast.

Maybe there's a 48-1000 in my future...

[Big Dave]

I would also ohm out the vertical oscillator blocking transformer. I had a bad one in one I did. They are not that hard to find.