Quote:
Originally Posted by liammc00
It being a funai means the mode switch is probably dirty and you don't have to do any soldering work to get to it. You just need to unscrew the mechanism from the top and two screws from underneath the chassis. Then left up the chassis a little bit to get to the mode switch. Another thing that can cause trouble are the tape end sensors the can sometimes get cold solder joints and I have seen were one of them has gone bad. I have had the belt There are YouTube videos on getting to the mode switch on funai VCRs from that time poried.
|
Hmm, I had pulled out every screw I could find but the mechanism wasn't lifting up at all.
10-07-2022, 07:23 PM
Threaded Mode