Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Antique Radio

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 07-28-2020, 12:45 AM
Kevin Kuehn's Avatar
Kevin Kuehn Kevin Kuehn is offline
Workin' Late Again
 
Join Date: Jan 2011
Location: WI
Posts: 3,976
Quote:
Originally Posted by vortalexfan View Post
I found a box of 47k Ohm 1W 2% tolerance Flameproof resistors that are branded RCA, a package with a 56K Ohm 1W 2% Flameproof Resistor that is Branded Sylvania and I have a package of 56k Ohm 1/2W Carbon Film Resistors that I had left over from when I was restoring my Meck TV last year that either one of those I think should work in this unit.

I think I could just solder it under the chassis between the two points where the resistor holder above ties into the circuit and then just leave the old fuse style resistor in the holder above the chassis for appearances sake (I cleaned up the glass housing of the old resistor and I looked inside and it looked like there wasn't anything in there anymore which might explain why it measured open).

Does any of these resistors I mentioned stick out as far as one that might work better than the other in this position?
Really any of them should be fine. According to the voltage/current chart that resistor will be dropping around 45v, so 45v x 2ma is a whopping 90mw of dissipation.

Quote:
Originally Posted by vortalexfan View Post
Also I found a couple of capacitors in my capacitor stash that might work in place of the old filter caps in the filter supply circuit, one is a 4.7 MFD 250 WVDC Electrolytic and the other is a 2.2 MFD 100 WVDC Electrolytic.

Would those work fine in the filter cap positions on this radio seeing as they didn't specify a Working Voltage for the original filter caps?
Assuming B+ at the second filter around 175v, I would use 4.7 mfd @ 250wvdc for 102 and 103. That'll give you some good headroom and a little extra filtering. For that matter you could use a couple 10mfd.

Quote:
Originally Posted by vortalexfan View Post
Also the 5,000 Ohm "B" Resistor in this radio's Power Supply/Audio Circuit measures open as well, and I was wondering what kind of wattage of resistor it is, its rather large and looks like it might be a 5 or 10 Watt WW Power Resistor but I'm not sure as it doesn't have any information written on it.
175v - 90v = 85v across the 5k.
85v/5000 = 17ma.
85v x 17ma = 1.45watts. So a 5 watt should be very conservative.

Everything is ballpark based on the values listed in the Bosch model 28 voltage/current chart and schematic.

Last edited by Kevin Kuehn; 07-28-2020 at 01:08 AM.
Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:28 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.