|
|
|
#6
11-24-2019, 11:40 PM
|
||||
|
||||
|
Couple of tips: Heat and desolder the leads and pins (file or poke the ends of the pins with a screwdriver to open them more after if needed) so you can see the lead in the hole before you install the base. If any lead is on the short side and difficult to get in the pin a single 3" strand from stranded lamp cord or a single solid core phono tonearm lead (Radio Shack used to sell good stuff) added to the end of the original helps to thread it right.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
|
Threaded Mode