Quote:
Originally Posted by zeno
As Tom C said the knobs just pull off. On some sets the horz hold
is an exception. The knobs are common & used up till abt 1970
with different sizes etc.
You will enjoy restoring this much more than the Philco. They were
not famous for there ease of service ! Zeniths are easy & as well built
as any & better than most if not all.
73 Zeno 
LFOD ! |
The knobs turned out to be much easier to remove than I thought, I found an old clamp used originally for pulling ICs out of their sockets and it worked flawlessly. You guys were right!  Hoping this'll be a nice break from the pain and suffering that is the Predicta chassis, point-to-point soldering is very therapeutic. Parts are on order...
__________________
When you lower your standards, you set a new standard!
ISO: Mitsubishi 6CT-338, Sony Chromatron 19C70/100, Yaou "Colornetron" GTC-9, etc...
|
10-20-2019, 08:30 PM
Threaded Mode