Are These Circuit Traces Bad

[DaveWM]

I don't see any problem with using metal films in that location. Be aware that even new carbon comps can be way off spec, always best to test. Tube sets are a bit more tolerance specs. if its marked 5% you should check before it goes in.

Just a warning, changing those parts may have NO effect on the problem, but its the only thing that comes to mind when you talk about vert bars commonly described as jail bars. The scope would let you see it before and after (the blanking) and may be enough to tell if its the problem at all, but even that is not assured since the waveforms may not be very reliable.

If I were in your shoes I would just change it and see. keep the old parts if by some chance the replacements make things worse (I don't see it happening but never hurts).

good luck with it.