Anyone have any Zenith Convergence Coils?

[zeno]

Originally Posted by TinCanAlley

If it were to screw completely out, it would be from the top. The bottom hole is about 3/16 or less while the top is about 5/16 or more (to lazy to do exact measurements).

You wouldn't happen to know where I can get a nice set of alignment tools and non-conductive as well?

For diddle sticks.
http://gcelectronics.com/order/SubCa...%20380-387.pdf
For hex tools there are 2 common sizes. The Zenith uses the
most common on & there is a smaller one sometimes used.
Also a square one for RCA. Screwdriver ones are mostly used in JP sets
& small radio.
Another tool that are almost a must have is a LONG 1/4" (#8)
nutdriver. Xcelite used to make it. About 30" long with a
magnet, gets to screws holding tuners & deep in anywhere.
Be sure a used one isnt worn. Should be lots of NOS around.
They also made a yellow handled one (dont remember size)
and a phillips. The phillips is essential for some old JP sets.

73 Zeno