|
|
|
#14
10-09-2012, 09:24 PM
|
|||
|
|||
|
3.58 trap? You mean 4.5 trap?
Before you go twisting coils verify its not something in the house interfering with the set. printers, these new electronic ballasts etc can cause that. Leaky/bad phase diodes can cause the jittering and bars. Leakage in the yoke can cause the bars too. Just because you changed the paper and electrolytics your not golden. I am seeing more and more leaky/shorted/lossy red and orange drops. The domino style mica. paper/mica are always bad where there is more than a few volts across them. Just some notes to consider 
|
|
|
Threaded Mode