Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 06-13-2011, 01:26 PM
Mal Fuller Mal Fuller is offline
VideoKarma Member
 
Join Date: Jun 2011
Posts: 110
Removing all the solder from the pins on the base is a necessary first step in saving your 12LP4.
If you heat the pins one at a time and then quickly smack the base on your work bench while the solder is still molten, this will effectively remove all the solder from each pin.
You should be able to carefully finesse each wire back into the base. Glue the base to the neck making sure each wire is fully inserted in each pin, I use Elmer's. Allow 24 hours for the glue to set.
Finally, with the tube face-down, solder each pin, removing your iron the instant the solder starts to flow.
Good luck.
Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:22 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.