|
|
|
#13
02-17-2007, 07:01 PM
|
||||
|
||||
|
I scored a nice rotating TV stand today at the thrift around the corner. It only cost a couple of bucks. If I had slid the Tv in the slot provided, it would be a perfect fit. I decided to put some rubber feet on the bottom of the TV to prevent from damaging the TV stand. The bottom of the Zenith has two metal strips that would gouge the TV stand. The wood on the top of the TV stand is particle board. Don't need to start damaging that. It will fall apart in an instant if got wet.
I also fished the back out of my shop. I need to align the chassis in the cabinet to make it fit properly. I am planning on pulling the chassis soon, and I will do that later. Some progress? polaraman
__________________
On the Bench: Master's Degree Thesis! 
|
|
|
Threaded Mode