Quote:
Originally Posted by Zenith26kc20
Just replaced the 150K ohm in my Maggie T-933. It went up to almost 300K ohm.
Back on and bright picture and terrible retrace. Loose 6LM8. Pushed it back in and good picture and vertical again.
Like you said, "Maggie Hell".
When I get a chance I'm going to check the 100K resistors in the back control board. Just don't trust them..
|
R101? Yeah, I replaced that w/o question cause I knew it would be bad, along with R85 & R108, a spot check of other resistors in the set found that others were still good.