Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #19  
Old 10-07-2021, 05:13 PM
LukeSimon LukeSimon is offline
VideoKarma Member
 
Join Date: May 2021
Posts: 183
Quote:
Originally Posted by kf4rca View Post
Get back with us and let us know the results.
If its not usable, you might could get a tube from a solid state portacolor that would work.
I know they made 9's and 13's, but not sure about 11's. The new tubes are "ultra-rectangular" and you might have trouble fitting them into the bezel. Also they have a different deflection angle.
The Portacolor CRTs are 70-degree, 10-inch, inline gun CRTs. Has anyone successfully swapped in a 90-degree CRT from the solid state Portacolors? In theory, the higher the deflection degree, the more deflection current is needed, and the Portacolor's horizontal deflection tube has a low to medium current rating. So it may struggle to fill the screen.



I used a BK490b CRT Tester to test the CRT. At first it tested bad, so I tested for heater to cathode shorts, which showed there was a short. So I ran the "remove shorts" function, and after a single spark, the CRT tested good. Note that this is a newer BK CRT tester, so it only has 6.3v and 12v heater options. The Portacolor 11SP22 has a 13.8v heater. If it tests good at 12v, then at the full 13.8v the emissions will be even better. I am going to test it again after another 7 days, to see if emissions decline a lot, which would indicate the damage during shipping has caused the vacuum to slowly go away. I have also found that with CRTs that have been kept in storage for multiple decades, they sometimes test bad at first, but if you use the CRT tester at max G2 voltage and minimum K to G1 voltage, you can get the cathodes to reactivate. It takes a minute or two, and it is much more gentle than using the rejuvenation options that drive 50mA through the cathodes.

The only spare Portacolor chassis I have for the 11SP22 is an "HE" chassis, which is made for the high voltage Portacolor CRTs. The 11SP22 is a low voltage CRT. I started a new thread here to discuss modifying a high voltage CRT chassis to work with a low voltage CRT. Comparing schematics, I think the changes are straightforward.
Attached Images
File Type: jpg 6468ACCC-6FB1-404B-AE2E-F1EE8C515DB8.jpg (90.9 KB, 145 views)

Last edited by LukeSimon; 10-07-2021 at 05:24 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:11 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.