Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #21  
Old 04-21-2020, 06:58 PM
vortalexfan vortalexfan is offline
VideoKarma Member
 
Join Date: Sep 2018
Location: Northern Indiana
Posts: 1,992
Quote:
Originally Posted by JohnCT View Post
Is there HV? A problem in the tuner or IF will still leave a raster if the brightness is midrange or higher.

Maybe tapping around the tuner is causing a sympathetic vibration somewhere in the sweep section and restoring deflection and/or HV.

Again, troubleshoot this forgetting everything you know about the TV (other than it worked after being recapped).




I'm not one of those guys that says never use a tube tester; I have several and find them useful to a degree. But what you need instead of a tube tester at this point is a good meter and a good scope (and an iso trans if it's a hot chassis).

I would start with the basics. Check the HV. Arc the cap of the HV rect to the cage. Scope the horiz drive to the horiz output. Check DC voltages at the CRT. If it has raster, scope the video from the detector back through the IFs.

A signal generator or a dedicated device like a B&K 1070/1077B or Sencore VA48/62 will allow you substitute drive and low level signals to see what's good and what's not.

John
Well I figured out what the problem was and I got it working like it should now.
My power supply caps were shorting against the chassis and some of the resistors for the Power supply circuit.

Because of how cramped it was by the power supply area of the chassis, when I originally replaced the old power supply filter caps I had to just use a free floating terminal strip for the power supply filter caps because there wasn't enough room for me to get a soldering gun into the chassis to solder the terminal strip to the chassis without accidentally burning through wiring insulation.

So apparently what the problem was that I didn't get the terminal strip situated so that it was sitting completely horizontal against the chassis so that the filter caps weren't touching the chassis or anything else near it, so when I hit the chassis with the screwdriver when it slipped the vibration of the screwdriver hitting the chassis was causing the terminal strip to move just enough to short the filter caps to the chassis and other components nearby which is why i would loose my audio and then eventually my video as well.

So I fixed the filter caps and I now have video and audio again.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:01 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.