![]() |
|
#12
|
||||
|
||||
|
On most sets using 1B3's There was a wire from the tube socket Pin 2, and 7 and it was
a single wire wrapped around the ferrite frame of the flyback once or twice. That was just to take a volt or two off the flyback to run the heater, The heater also was the cathode of the diode tube..... I would use pin 7 , but I'm going to go out on the limb and say either pin would work.....? I'll have to look it up though.....
__________________
Yes you can call me "Squirrel boy" |
| Thread Tools | |
| Display Modes | |
|
|