Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #18  
Old 07-07-2012, 07:30 PM
Username1's Avatar
Username1 Username1 is offline
Not sure how I got here.
 
Join Date: Dec 2009
Location: Orange County NY
Posts: 3,668
I agree with Marty you should try turning the tube an all directions and try zapping it. But I think an hour or so with a good bright light, and carefully inspect the neck of the tube to see if there is anything visible as far as a shorting item goes..... Use an ohm meter too, check it to see if its short at 0v. operating voltage, or does it short only on full operating voltages. And at last resorts don't forget to remove the socket if the short is there at 0v. It could be a mechanical short outside the glass envelope.
I don't think I would do the 3,0000uf cap at 400V, you could weld with that much current. I would offer this: Tap the end of the tube, tap it harder, possibly vibrate it with a cell phone motor on the tube neck. And turn the tube, put the bad gun top, bottom. But I would still keep the gun horizontal, not lay the tube face up or down.
But that is just me. I got a lot of tubes going again with heating the tube, and wacking it good with a screw driver. Just don't break it, I bet you will run the possibility of making progress fixing this as long as you take your time and think it out.
__________________
Yes you can call me "Squirrel boy"
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:23 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.