![]() |
|
|
|
#1
|
||||
|
||||
|
Just curious - is there any significant difference between a 10T1 and the earlier 800 ?
|
|
#2
|
|||
|
|||
|
Ge10t1
How can I get an appraisal for this set? Unknown if it works.
|
|
#3
|
||||
|
||||
|
These sets can sell for $50 - $200 depending on condition and location.
Location is very important because they are difficult and expensive to ship without getting destroyed. Condition, the higher end should have all parts, no cracks, good CRT and clean chassis. Probably the majority have at least one crack on top near the vents, many are cracked on the bottom. In unknown working condition but decent cosmetics I would say the average is $100. I believe the difference between the 800 and the 10T1 is the 800 has a rectangular mask, the 10T1 has a Double D, that's been the case on most of them I've seen, some aren't that way but they may have had the case, or at least the front, swapped out sometime in the last 60 years. |
|
#4
|
||||
|
||||
|
Other than the crt masking the big differences i spotted are, V7 A,B (6AL5) has been replaced with 1N64 and 1N65 diodes used in the detector and DC restorer circuits. if you have have a early 800A,B a twin diode (25Z6) is used in the damper circuit, changed to 25W4 single doide and a fly back with more taps in 800C,D. just like the 10T1.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|