![]() |
|
|
|
#1
|
|||
|
|||
|
the contrast is somewhat lacking, checked AGC, subbed a new video amp tube with a NOS, not much better. I have not checked but suspect a weak bypass cap in the video amp circuit.
|
|
#2
|
|||
|
|||
|
ah I see another stage of video amp ahead of the 12BY7. Think I will give it a try. I also have to recheck the kine bias and make sure I have that set right. One last thing is there is a video peak switch I think I will play with. All the slide switches on the back seem a bit iffy, prob should give them a shot of clean juice.
|
|
#3
|
|||
|
|||
|
3rd pic IF tube (6jc6) had a short, new one resulted less ringing look to the pic. its getting good enough for a screen pic, will post one soon. Checked the HV right on 25kv and very well regulated. I need to go back and check the HOT and shunt tube currents. The 6fq7 horz osc tube tested pretty weak but seems to be working ok. I will swap it out after I get the HOT current check setup to see how much difference there is with a stronger tube.
The tuner needs the normal cleaning but not going to get into it now. Overall this one has been pretty much trouble free. |
|
#4
|
|||
|
|||
|
ARGH, I went out to get a pic, turn on set, GREEN only. I looke around and feel a power resistor near the R/B amp, stone cold, and I notice a brown wire that looks real bad, sure enough its broken loose. No way I can fix it with out pulling the chassis, so I will just make a note and put it away for now.
|
|
#5
|
|||
|
|||
|
back in business, managed to get a jumper in there. I bet this was the problem all along (not the amp tubes but the wire, prob just got bumped when subbing out the 6gu7). done for now
|
| Audiokarma |
|
#6
|
|||
|
|||
|
that contrast is maxed out, tried the AGC adj for max contrast (just before losing sync). I am assuming its a gain issue somewhere as on my other sets too much contrast is easy to get. I still suspect the bypass cap in the video amp, but its not going ot be easy to get at so will have to wait. I just wanted something easy to work on and see if I could get it going quickly.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|