![]() |
|
#8
|
|||
|
|||
|
Get yourself a 100 watt minimum light bulb, if you can get a 150 watt outdoor flood light even better. If you dont have a socket to screw it into solder wires to it. You can cut the plug off a lamp and strip the wires too.
Tie the bulb across the back of the fuse with the fuse out. If you have a short the bulb will light up fairly bright. If working properly the stereo should only light the bulb a tiny bit if at all. First thing I would do is remove the output transistors and see if the short goes away. If so you can easily test the transistors using the diode check on a multimeter. I see what look like mismatched output transistors there. I works on high power amps used in nightclubs and its absolutely critical the output transistors are matched, not only the number but the tested gain figure as well. I know its not that critical on low power stuff like this but when I see two totally different looking cans its very suspect. Im really looking at those output transistors..... Generally its cool to 'stick anything' in there on low power consumer stuff but not always. Is there a model number on the back of the entire unit? |
| Thread Tools | |
| Display Modes | |
|
|