![]() |
|
|
|
#1
|
||||
|
||||
|
I haven't run into anything like this before. It appears to be a huge non-polarized capacitor, but the rating is strange. 3VNP 1.0 ohm 60 Hz. Would that be 3 volts non-polarized with an impedance of 1 ohm @ 60 Hz ?
I plugged 60 Hz and 1 ohm impedance into this site and came up with 2.65258 mF (about 2,650 uF) :Any thoughts on what to use for a replacement ? Mouser has some 2,200uF non-polarized caps. Maybe that's close enough ? It's C4 in the schematic. ![]() ![]()
Last edited by bandersen; 06-26-2010 at 09:50 PM. |
|
#2
|
||||
|
||||
|
That's certainly what it seems to be. I'd think the 2.2 mF caps would be close enough. Probably well within the tolerance specs.
John |
|
#3
|
||||
|
||||
|
This is a situation where a cheap cap checker would come in handy. You can test for unknown values simply by checking where the eye tube closes on the dial scale. All that aside, that has to be the most bizarre method of labeling a cap I have ever seen.
|
|
#4
|
||||
|
||||
|
I do have a couple vintage RC bridges and will try them out. The ranges don't go anywhere near 2,600 uF though.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|