hello all, i just felt like picking someones knowledge on this motorola since getting it to this day i cannot figure what might cause the lines i have on the left side and are about 6 inches long from the bottom up and the lines seem to favor a color each and the convergence is off in that corner which can be seen with scene changes or something crosses that path almost like a few beams are not where they should be. i thought the yoke might be the problem but how to tell without a ring test i dont know. the hv is a bit low and the width was not right or the height but was able to adjust all of that but the controls for those are maxxed to one side so something is not right and i really dont believe its the fly. if i max out the screen control the picture will pull in on the left and will be able to see these lines better and with the control all the way up and having the hv being low the picture of course will wash out.could there maybe be some sort of magnets missing from a spot on the yoke or around that area, as im scraping the bottom here trying to figure this out. i already recapped all the lytics and many hv caps in the horiz section. they say measure hv with the yoke in place then unplug it and measure again i did and plugged in the hv does go up but is it possibe for it to have a very miner short in the yoke to give these types of lines and low hv as well but yet still work nice with good color.
HELP.....
12-09-2011, 09:16 AM
Threaded Mode