Westinghouse TV no picture : Strip or fix?

[JesusJones]

Alright so I put the diodes in, No issues. And booted it up. And once again was left with about 30 volts Then when the heaters finished heating it dropped.
I traced where the ac mains lines actually go and one goes to the damper tube base. But is not actually connected to the tube. Its connected to a sand resistor. Some one else mentioned it could have been this resistor.
I measured in this resistor at 25 ohms. Is this an average value for this type of resistor or is it wayy off?

The other mains goes to ground then the one of the new diodes I put in.
Also one side of the mains is hooked up to a small cap then travels to another larger cap. To ground again..I think