View Single Post
  #3  
Old 03-29-2015, 10:08 AM
N2IXK's Avatar
N2IXK N2IXK is offline
Technohippie
 
Join Date: Apr 2011
Location: Sittin' on the "Group W" bench...
Posts: 817
Clipping out the old part and soldering the replacement to the stubs on the top side of the board was standard procedure if you were fixing the set in the customer's home. Saved the time and effort of pulling the chassis to get at the bottom of the board.

I wouldn't recommend it for restoration work on vintage sets, though. Would really look terrible to see every cap and off-spec resistor in a set replaced in that manner...
Reply With Quote