View Single Post
  #6  
Old 06-19-2009, 07:51 PM
wa2ise's Avatar
wa2ise wa2ise is offline
VideoKarma Member
 
Join Date: Dec 2002
Location: USA
Posts: 3,147
Quote:
Originally Posted by waltchan View Post
Not made in USA, but I have seen one converter box that is Made in Bulgaria in Europe than in China sold at Fry's Electronics.
That's the Channel master CM7000. It's a good box, and it also offers S video. Fry's has them on sale for about $50 every few weeks.

I modified mine to allow me to turn off the chroma subcarreir so it can produce a pre-color TV B&W only TV signal, like that before 1953 (that's when NTSC color was approved by the FCC). Thus I can feed my late 40's early 50's B&W TVs and have nice sharp pictures without chroma checkerboard crawling thru it.


Looking at the picture, look for the cap arrowed. Near the STV6433 chip (this chip filters and merges luma and chroma to create the composite video output (yellow RCA jack, and also a special composite signal designed to be modulated (group delay pre-distortion and a notch to make room for the sound IF carrier at 4.5MHz) onto a TV channel, which is why I wanted to use this box's intermal TV modulator instead of an external one). What we are going to do is intercept the chroma before this chip, with a switch that will either pass it to this chip, or switch away from the chroma source and switch to ground. I placed this switch before the coupling cap, as the STV6433 has an internal video clamp that charges this cap during the horizontal interval (between scan lines) to give the internal amps inside the chips proper DC biasing. Switching away from the chroma source to ground still gives this charging circuit something to work against.

To do the mod: remove but keep the cap arrowed in the picture. Now stand it upright and solder it to the solder pad it was soldered to closest to the STV6433 chip (see drawing at the bottom of the picture. On the now top end of this cap solder a wire that will go to the center pole of a switch. Another wire soldered to the now unoccupied solder pad goes to one side of this switch, and the other side of the switch goes to ground. Label the switch "color" and "B&W" accordingly.
__________________
Reply With Quote