Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 01-20-2007, 01:52 PM
jpdylon's Avatar
jpdylon jpdylon is offline
<-- sucker for old sets.
 
Join Date: Apr 2005
Location: Knox County, Tennessee
Posts: 1,675
so far...

here's what i have run into

pin 8
sams says 170vdc --I have 190v

Pin 5
sams says -70vdc --i have fluctuating voltage between -1 and -5

Pin 4
sams says -70vdc --i have 0v

pin 3
sams says -65vdc --i have 0v

Drive voltage at pot is 273v


R96 has jumped from 47 to 106 ohms --that's probably one fault. Pin 5 side is -2 volts, other side of R96 is -91 volts

Still can't figure out why I'm getting 0v at pin 3.
Attached Images
File Type: jpg findings.jpg (99.5 KB, 24 views)
__________________
Jordan
Reply With Quote
  #2  
Old 01-20-2007, 03:35 PM
wa2ise's Avatar
wa2ise wa2ise is offline
VideoKarma Member
 
Join Date: Dec 2002
Location: USA
Posts: 3,147
Quote:
Originally Posted by jpdylon
here's what i have run into

pin 8
sams says 170vdc --I have 190v

Pin 5
sams says -70vdc --i have fluctuating voltage between -1 and -5

Pin 4
sams says -70vdc --i have 0v
That looks suspicous, maybe a heater-cathode short either inside the tube, or in the tube socket? With the power off, take an ohmmeter measurement between the cathode pin and the chassis ground. Also check resistors R98 and R99, the parallel pair should measure 110 ohms. A short on pin 3 could overheat them and blow them up.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:05 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.