![]() |
|
#19
|
||||
|
||||
|
John -
Yes, I wanted to verify that the oscillator was on frequency after recapping and changing resistors in that section. Plus I wanted to make sure that the horizontal hold control hadn't been disturbed (the chassis has only been in and out about eight or ten times so far.. )The waveform I am seeing is at the grid pin of the HO tube socket. I've checked R729 and it is within spec. I have the HO tube out for testing, but am going to put it in and see what I get at that pin as well. I also plan on measuring the screen voltage then as well - with the tube out the screen voltage is simply B+ - and a bit high at that. I haven't looked at C448 as it is a ceramic according to the parts list, but could measure it and change it if necessary. As far as I know, the damper isn't getting hot. I haven't looked at it closely though; I focused on the HO tube since that was the first one I saw with a glowing plate. Will keep everyone updated.... ![]() Jim Will remove the socket from the CRT and see what happens when I get home tonight. |
| Thread Tools | |
| Display Modes | |
|
|