![]() |
|
|
|
#1
|
||||
|
||||
|
And here they are!
Got it home and unloaded.
Pulled the back and tested the CRT and it's excellent! Also checked the date on one of the small tubes, 48-60 so my guess of 60-62 was pretty close. I went ahead and plugged it in, first with the remote active, nothing happened, even jingling keys in front of the receiver had no effect so I switched the remote off and then the set came on. It has vertical problems, just a single line across the tube, slight hum in the sound but it tunes stations albeit with a very dirty tuner. One other little problem I haven't looked into is the tuner knob spins without turning the tuner, something's stripped, also the up-down switch won't change channels either, unless the remote has to be on for that to work? There is the knob in back that does work the tuner so I know it at least turns and the lighted numbers in the center of the dial change with it so I'm guessing just the knob itself is bad. The cabinet has a few minor scuffs and nicks, mostly on the top but overall a very nice example of a limed oak type finish. My house is at the breaking point for new acquistions, especially large ones so something coming in meant something had to go out, in this case a badly beaten Phiilco 48-2500 cabinet that has been sitting in the garage for several years! It'll hit the dumpster after I strip out all the useable pieces. Last edited by Eric H; 10-17-2006 at 10:04 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|