Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 07-18-2006, 02:09 AM
Tubejunke's Avatar
Tubejunke Tubejunke is offline
VideoKarma Member
 
Join Date: Apr 2003
Location: Martinsville, VA
Posts: 1,823
I'll post pic's as soon as I get some batteries for my camera and get the set back together. I tried a slow warm for about 4 hours with a 100 watt bulb. Everything was looking great. All the tube filaments bareley glowing and nothing was getting hot. Well when I applied 110V all hell broke loose. The transformer sounded a bit loud and next thing I know my 4 way recepticle circuit protector kicked out (which was good). Sounds like the typical electrolytic trouble in the power supply. I diconnected several sections in the multi section cans and checked them with an analog ohm meter. The bad part here is so far I havent found anything that looks like a short. The needle goes to zero and slowly gains high resistance which should be pretty normal.

With a bad short I would think I would find the needle decending to a low resistance or staying in one place with little or no "sweep" action. If I'm wrong please correct me. Now I did notice that one newer lookin 3 section can had a good strong hold on zero for a couple of seconds before gaining rapid resistance on all of the sections. One of the older ones did have a kind of weaker reading if that makes sense. The needle would sweep but with no hold at zero when polarity is reversed. Could that be a short?

I do remember when I attempted reviving my 8t-243 I replaced all of the power supply cans plus many others and the original problem of eating LV rectifiers after 3 seconds of operation was gone but I never found an out and out bad reading with my multimeter. I just started replacing things. Is there something I am doing wrong? I hope and pray the transformer is not the problem. I dont want to sacrifice my 8t-243 chassis for the sake of the much more handsome TC-127. It looks like you could swap the crts and have the same set. Probably not that simple.

Any idea??
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:07 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.