Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old 01-22-2006, 11:09 AM
andy andy is offline
VideoKarma Member
 
Join Date: Jul 2002
Posts: 4,004
Most Sony's have a pretty complete set of geometry adjustments, even a 21". They will mostly be small pots scattered around the deflection board. Look things like "pin amp", "pin phase" and "keystone", or abbreviations of those names. They function like the controls on a computer monitor. A PVM monitor should have lots and lots of control to play with and should end up with near perfect geometry. A cross hatch generator is a must; don't even start until you have a way to display one. There will be two sets of controls if it supports underscanning, so make sure you adjust the right set. Also, be sure to adjust the geometry after the size and centering because they interact. Most Sonys look a lot better after a little adjustment.

Center convergence is adjusted by the rings on the neck of the CRT and the H Stat control. Edge convergence is adjusted by tilting the yoke. There may be a few pots and coils on the yoke that also affect dynamic convergence.

Last edited by andy; 01-22-2006 at 11:11 AM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:32 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.