Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early Color Television

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 12-19-2005, 04:27 PM
old_tv_nut's Avatar
old_tv_nut old_tv_nut is offline
See yourself on Color TV!
 
Join Date: Jul 2004
Location: Rancho Sahuarita
Posts: 7,815
Regarding the brightness issue, a simple calculation shows:

Assuming
1) 100% collection of all the CRT light output (of course you can't),
2) a 5-inch CRT and a 50-inch picture;
that is an area ratio of 100 to 1.
In this overly optimistic case, to make a bright (50 ft-lambert) picture requires the image on the CRT to have a 5000 ft-lambert brightness, roughly equivalent to a sheet of paper in full sunlight. Any practical inefficiencies due to f-number of the optics, etc, either lowers the viewed brightness or requires a brighter CRT (The vertical directivity of the screen compensates this to some degree.)
Reply With Quote
  #2  
Old 12-19-2005, 07:47 PM
vintagecollect's Avatar
vintagecollect vintagecollect is offline
VideoKarma Member
 
Join Date: Jul 2005
Posts: 658
early projection not suitable for everyone

I agree, screen brightness was not that of crt from rear projection, owned a Kloss model one from 1980? Watched it using a wall --- original curved screen not vailable-these took up a lot of space. Corner convergence was bad due to this. Produced a beautiful picture and worked for many years.

Then I owned a 3 CRT zenith similar projector from late eighties. Was designed to shoot on flat wall, had much more brightness--can be watched with room lights on-- showing 10 foot screen image. The convergence to tweak right was a bear , proper convergence was only acheived right before I sold it. Still a great set-- had to buy special cabinet for unit to be at right height and parallel to projection wall. These units being expensive usually people only sold them if they had major issues. These were generally hard to find in good used shape.

Last edited by vintagecollect; 12-19-2005 at 07:52 PM. Reason: .
Reply With Quote
  #3  
Old 12-19-2005, 08:06 PM
andy andy is offline
VideoKarma Member
 
Join Date: Jul 2002
Posts: 4,004
---

Last edited by andy; 12-07-2021 at 03:26 PM.
Reply With Quote
  #4  
Old 12-19-2005, 10:23 PM
old_tv_nut's Avatar
old_tv_nut old_tv_nut is offline
See yourself on Color TV!
 
Join Date: Jul 2004
Location: Rancho Sahuarita
Posts: 7,815
A single-CRT projo with color wheel will flicker badly unless it has video storage so it can run at 3 times the frame rate. At that point it will still have noticeable color fringing on motion on a large screen. Single-chip DLP projos with color wheels run at up to 360 fps or so to reduce the problem.
Reply With Quote
  #5  
Old 12-19-2005, 11:29 PM
andy andy is offline
VideoKarma Member
 
Join Date: Jul 2002
Posts: 4,004
---

Last edited by andy; 12-07-2021 at 03:26 PM.
Reply With Quote
Audiokarma
  #6  
Old 12-20-2005, 01:23 AM
Steve K Steve K is offline
VideoKarma Member
 
Join Date: Sep 2002
Location: Thousand Oaks, CA
Posts: 503
There was at least one plan that was printed in an electronics magazine in the 50s that had a color wheel in a Norelco projection set. The wheel only needed three filters instead of the usual six. I believe that one of the early CBS prototypes used a projection tube as well.

Steve
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:50 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.