Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early Color Television

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #24  
Old 10-21-2005, 06:55 PM
old_tv_nut's Avatar
old_tv_nut old_tv_nut is offline
See yourself on Color TV!
 
Join Date: Jul 2004
Location: Rancho Sahuarita
Posts: 7,815
That Dimensia IQ demod design was ingenious in that they found a way to make an I channel delay line with only one IC pin (plus one external transistor). As an analog IC designer, I thought that was one of the neatest tricks I ever saw. Essentially, they tied the input of the delay line to ground, then drove the delay line output and what would normally be the delay line ground up and down with the input "I" baseband voltage. They then used the same driving pin to sense the output current!

Despite my admiration for the IC design, When I tested one of those sets for chroma resolution (working at Zenith), it was essentially no better than the R-Y/B-Y sets. The I channel high frequencies were quite attenuated. It appeared that there was too much phase distortion in the IF to allow the I channel high frequencies to be boosted to a useful level. I went through some effort to design a better IF for a possible wideband design myself, but concluded that the NTSC got away with their system design partly because tests were done on small screens. My basic conclusion was that NTSC needed a more symmetrical Q filter in the transmitter - it should have traps on the upper and lower edge that match the 4.5 MHz sound trap (+/- 900 kHz from the chroma carrier). If the Q sidebands transmitted would be sharply curtailed beyond +/- 500 kHz, there could be no quadrature crosstalk from Q into I, and it would behave like the NTSC intended - but NTSC Q filter specs were too broad, and any reasonable IF would show quadrature distortion and therefore the I response could not be boosted to the theoretical value. I proved this by modifying the filters in an NTSC encoder -and when we saw how well it worked, we gave up trying to design an I/Q set, since there was no way to go back and modify every encoder out there.

Last edited by old_tv_nut; 10-21-2005 at 06:58 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:53 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.