Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early Color Television

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 01-06-2026, 08:27 AM
Alex KL-1 Alex KL-1 is offline
VideoKarma Member
 
Join Date: Jan 2021
Location: Brazil (Paranį)
Posts: 515
Sorry if the following was said or asked before, but: the screens voltage also change with brightness change? Also, the potmeter itself perhaps is drifting or the circuit that fusnishes the negative voltage (is derived from...?)
__________________
So many projects, so little time...
Reply With Quote
  #2  
Old 01-06-2026, 10:22 AM
Penthode's Avatar
Penthode Penthode is offline
VideoKarma Member
 
Join Date: Jun 2009
Location: Kitchener/Waterloo Ontario Canada
Posts: 1,463
If the voltages are off on the the brightness pot, there are only a few components to check.

I am suspicious of the 11 volts positive. I would measure the DC voltage on the input of the delay line for if the 2ufd electrolytic is leaky, (C402).

The only other source of a higher than normal DC are the 1st Video Amp cathode resistors R 402 and R403.Try measuring the voltage at the junction of the two resistors and the cathode of the 6AW8 first video amp cathode.

Problem behavior question. I understand the problem is that the CRT is bright when first powered and gets darker over a period of 10 minutes or so? If that is the case, when power cycling, how long must the set be off to when it is repowered the return of the from cold high brightness problem is observed?

Last edited by Penthode; 01-06-2026 at 10:25 AM.
Reply With Quote
  #3  
Old 01-06-2026, 12:03 PM
old_coot88 old_coot88 is offline
VideoKarma Member
 
Join Date: Sep 2009
Posts: 2,654
Then there's the old quick'n'dirty 7 seconds off test for borderline weak tubes. Although not for that specific purpose, the test might provide some clues.
With the set warmed up and in the fault mode, turn it off for 7 seconds, then back on. Does the fault remain once the tubes stabilize, or... ?
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:24 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.