Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Recorded Video

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 12-19-2025, 05:53 PM
redk9258 redk9258 is offline
VideoKarma Member
 
Join Date: May 2017
Location: Troy, IL
Posts: 164
You should not have let anything move when you had it apart (obviously)! This belt is a bitch to change! It probably would have been a good idea to clean the mode switch since you were so deep in. Hopefully these pictures help. Notice how the holes have to line up. When you put the control cam back on there is a projection that goes into the groove. Also note that One screw is shorter than the 2 others. If this is out of place, the mechanism will jam. While you are in this machine, check the power supply caps. I will almost guarantee capacitor C17 - 3300uF @ 16V will be bad. This will cause any tape to play in EP instead of the correct speed. Check ESR on the rest too, if you can. It might be best just to replace all.
Attached Images
File Type: png Screenshot 2025-12-19 165124.png (32.1 KB, 16 views)
File Type: png Screenshot 2025-12-19 165055.png (32.1 KB, 16 views)

Last edited by redk9258; 12-19-2025 at 06:00 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:42 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.