![]() |
|
#14
|
||||
|
||||
|
Probably. There's a felt pad in each corner.
Time for a power up attempt. ![]() OK, nothing. B+ is close to spec, but no HV and no sound. Started by replacing a few caps on the horizontal oscillator. One had split open and one looked like a mica cap, but it's leaky paper inside. ![]() That got the oscillator running and we have HV ![]() ![]() Vertical is crunch though so went after that next. Replaced a couple caps on the vertical output and that helped a lot. ![]() ![]() Injected a signal next but cannot lock horizontal. Just not enough range on the freq or phase controls. ![]() Replaced a couple caps on the 6AC7 AFC reactance tube. All of these are paper caps and all are bad. The one on the left was actually getting warm. Replacing that got a lock! ![]() ![]() Not bad for just replacing a few caps and open power resistors.
|
| Thread Tools | |
| Display Modes | |
|
|