Admiral 19A15 7” CRT gasket

[Electronic M]

I always thought those were a hard plastic part of the lucite mask assembly. I've never seen one degrade enough to be noticable from the front of the cabinet (if there's something aged inside the cabinet that can only be seen if dismantled that's just part of the patina).

I do have the mask assembly from a 17T1 Chinese grille bakelite set that had a wrecked cabinet...It's a white border double-D screen mask (not gold rectangular like yours) so I'm not sure it's useful to you.

[Kevin Kuehn]

The Admiral mask doesn't show much from the front like on the Motorola, so it shouldn't be too difficult to put something like door seal around the perimeter of the CRT face. Even a piece of plywood or Styrofoam insulation could be sculpted to fit. And a CNC router would come in handy.

[LADR]

Originally Posted by Kevin Kuehn

The Admiral mask doesn't show much from the front like on the Motorola, so it shouldn't be too difficult to put something like door seal around the perimeter of the CRT face. Even a piece of plywood or Styrofoam insulation could be sculpted to fit. And a CNC router would come in handy.

I talked to a friend about the gasket today and he suggested basically the same thing. I SHOULD get away with using foam tape. I had the idea of borrowing a good gasket from someone and have a new one 3-D printed. I'm not sure, however, how well solid plastic would do in place of rubber.

[Kevin Kuehn]

Walmart and Hobby Lobby both sell craft foamie sheets in 4 and 8mm thicknesses. I think a narrow ring spray adhesived to the face of the crt will make a decent dust and shock seal. You really don't want to glue any gasket to the rear painted surface of the plastic mask, as it could peel the paint if you wanted to remove the crt later.