Quote:
Originally Posted by Electronic M
I haven't done a full voltage comparison between both chips. It kinda scares me taking measurements on the chip in the good set as I'm worried I'll accidentally short pins on the good set taking measurements and end up with 2 dead sets instead of 1.
|
The service manual should have voltages present on certain pins, under certain conditions.
It's nice to be able to compare to a working set, but in the case of such large, cumbersome chassis, I would probably just follow the SM
Also I think if you want any quality feedback you need to supply a schematic by linking an image to it. You can circle components you are talking about with red to call attention to them.
09-21-2024, 12:39 PM
Threaded Mode