Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 09-04-2024, 01:42 PM
Chris K Chris K is offline
VideoKarma Member
 
Join Date: Jun 2022
Posts: 1,534
Quote:
Originally Posted by bandersen View Post
I think you have an EICO 369? It has one built into the output lead as shown in this diagram.

Now let's be clear - you will still get RF output without this resistor. You can still do an alignment without this resistor.
However, the get the best results (and keep your generator happy) you should use one. It will also mean your output level meter should be accurate,

Notice there is also a resistor and 1,000 pF capacitor inside the demodulator probe.
That's what Pentode was talking about adding. It's a low pass filter and will help remove noise if you have a fuzzy trace.
I'm not sure based you your scope screenshots if that's really what your trouble is.


I had just pulled out both those probes from the 369! Unfortunately, they have the funky male connector on the end and not the male BNC. I'll have to Amazon some overnight and get them swapped out. New Tektronix 465 coming tomorrow as well so maybe a reboot...(another thread???) would be a good thing to do.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:11 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.