![]() |
|
|
|
#1
|
|||
|
|||
|
The small parts near the 7400 MOSFET and the circuit labelled "panorama" (better to check these first), and parts in series with the yoke, are worth to testing, if no more idea crosses the mind just now.
BTW, adjusting the parts in the gate of the 7400 will change the strengh of the E-W actuation, butit also can distorts the intended waveform, probably, since it have some cap in it's network. The E-W adjust probably will be with various parameters, like H parabola, H size, H bow etc, at the service menu. The code depends on manufacturer.
__________________
So many projects, so little time... |
|
#2
|
|||
|
|||
|
Quote:
There's no parabola parameters either in the service menu of this model. I can show you later what I have. I've checked all parts in the EW circuit and they all checks fine but will check again. The last thing to check is everything in series with the yoke, I guess. I noticed yesterday that L3 is very unstable, jumps from 130-150 V back and forth. I don’t know if that’s normal? Last edited by Claustrofob; 09-04-2024 at 07:06 AM. |
|
#3
|
|||
|
|||
|
Quote:
The E-W MOSFET is feed from µC as show in the schematic? Since you have schema, also not hurts if you play a little with the R values near the E-W MOSFET. Any bad progress and you can revert to original.
__________________
So many projects, so little time... |
![]() |
| Thread Tools | |
| Display Modes | |
|
|