![]() |
|
|
|
#1
|
||||
|
||||
|
Listed in the SAMS is a rather detailed step by step procedure under horizontal osc adjustment / complete alignment, this sounds like what is needed as a slight retouch most likely won't work, I have not ever had to do this myself, but if it is way off, these steps may help if done as shown.
Also, the RCA service data may have more detailed steps on how to align this area.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために |
|
#2
|
|||
|
|||
|
Quote:
|
|
#3
|
|||
|
|||
|
OK well the first step in a complete realignment is "Tune in a station and adjust the fine tuning for best sound quality. Turn the T-108 frequency adjuster on the rear until the picture is synchronized." I've turned it through its full range slowly and there's no spot where the picture syncs. It gets as close as I've gotten it before, but never full sync.
|
|
#4
|
||||
|
||||
|
“a picture that becomes somewhat locked for a second and is kinda clear and aligned to horizontal chaos”.
Under what conditions do/did you observe the “clear” picture? jr |
|
#5
|
|||
|
|||
|
When I fiddle slightly with the horizontal hold or the discriminator frequency or the fine tuning or the brightness pot or the contrast pot or the horizontal drive pot... Let me say when I said clear and stable...I'm talking for less than a second. It seems to change from almost think I can pull it in to awful to worse than awful back to bad almost think I can pull it in etc. I wish I could post a video. It would explain it so much better.
|
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|