![]() |
|
|
|
#1
|
|||
|
|||
|
Take a look, below are 3 scope images using different cables to feed signal into the tuner converter control grid (Test Point A). Note I had to turn down the vertical scope by one setting for the direct connection cable as the signal came in stronger. I tried to overlay all three images in photoshop, each was slightly different in horizontal or vertical size but I would have to argue the curve and marker locations and marker attenuations all look very close.
Maybe antidotal but while waiting for the set to warm up I was watching some content via the converter box and the picture to me looked better, so at least I am not making it worse.
|
|
#2
|
|||
|
|||
|
I may try to further tweak the IF alignment but its maybe about as good I can do. Would there be any components that are suspect? See below for all of my in-circuit measurements, I did replace the 2 film capacitors also using NOS tubes that test very good, I guess I could swap just to see what happens.
![]()
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|