Quote:
|
Originally Posted by bandersen
Basically, wherever work was done, there is damage.
...
|
Bob, that's a shame. I will admit to damaging terminal strips and tube sockets a few times in my "early years" of restoration. But lately, I have a lot of patience and very, very carefully remove all of the old wire from the component. In the last set that I worked on, many times I would have to unwind two or three components which were wrapped on top of the wire that I needed to replace. If it were resistors (often) they usually got replaced unless they were spot on value. I don't think that there is a value that I don't have now. I have been collecting them for quite some time.
Anyway, sorry to blabber in your thread. I look forward to following this.
09-03-2023, 03:13 PM
Threaded Mode