![]() |
|
#11
|
||||
|
||||
|
Good Afternoon,
I think rewinding that coil is not a good idea.... I think at this point you should think about 2 possibilities. 1. The incoming burst signal is distorted because of a bad part, or there is the other possibility, 2. A19 is not tuned to the burst signal..... I thought about this a lot, and found stuff written about this group of circuits to refresh my memory on every inch of these circuits. None of the circuit descriptions go into "restoration" and replacing parts because they are believed to be out of tolerance. So when you consider the large number of parts replaced in this tv, I bet there are lots of circuits somewhat out of tune. As of right now I have not seen a post where anyone has said A19 has been adjusted for anything..... I wonder if that coil should be adjusted to see if it's out of tune and causing the burst signal to be off by a little bit. Back to A18, Timmy can you take that out and send us a good close up picture of it? While I'm a fan of replacing parts that are out of spec, this one is only out of spec as far as it's DC resistance goes..... You really need an Inductance Tester Gadget of some kind to tell if it's Mili-Henry's or Micro-Henry's are out of whack, or not. And wouldn't ya know it, Sam's don't give it's value..... I would say, that if you really want to rewind that coil, make a new one, but keep that one as is - for when the replacement don't work.... Timmy, I think over the course of this thread you said you have a color bar generator? If that is true, it may be time to get it out, set it up, run it through the tuner, and try adjusting the tv Color & Tint to show them as they should look, I think third from the right is suppose to be magenta - Kinda like Purple.... I think you should try and set this up and see if you can figure out if there is actually a color - or several colors that are not being reproduced properly. And with a color bar on the screen try and adjust A19, and see what happens..... I would think turning it would kinda make the color saturation go up & down as it's passing the burst... So you would be peaking the coil for burst signal.... Possibility 3. This is all wrong..... Problem is in some other part..... ..
__________________
Yes you can call me "Squirrel boy" |
| Thread Tools | |
| Display Modes | |
|
|