![]() |
|
#11
|
||||
|
||||
|
Just to re-enforce what EM said the Color Killer to basically a do-dad that turns off
the color osc, & other color circuits when you are watching a B&W tv show. It was found that if those circuits were not turned off while a B&W show was on, it produced annoying color effects outlining items, or characters on the screen. One way to Properly adjust the color killer knob is to turn to a channel broadcasting mosquito races and turn the color killer knob until the races are only B&W. When you switch over to a color program, it should work as normal & you see the program in full color. Mosquito races can be found on any analog channel that has no programing being broadcast. I did not see any confirmation that this is that same Motorola TS-907 that you have worked on before, but I suspect it is..... If the Local color osc. does not sync with the burst signal coming in on the tv signal, you will get that "barber Pole" effect on the screen. You should look over at the V21, V22, & V23 tubes & that area for possible troubles..... As always, without a scope, starting off with voltage checks is the best idea, If all is well with that, you can always tweek coils, but document each move down to the smallest mm. And try to put them back if it don't get better. Remember 6GH8 Tubes are trouble. .
__________________
Yes you can call me "Squirrel boy" |
| Thread Tools | |
| Display Modes | |
|
|