Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 04-25-2023, 03:40 PM
timmy's Avatar
timmy timmy is offline
VideoKarma Member
 
Join Date: Jan 2011
Location: Delaware ny
Posts: 3,719
Quote:
Originally Posted by Chris K View Post
Looking at Bobs schematic for the ballast and pictures of what I built I made a single change. The thermistor was installed between pin 5 (due to the pin switch for this chassis) and the intersection solder point at the top for the resistors. I did this because my chassis had the older version of the ballast installed originally and that made the pin setup different… a switch from pin 6 to pin 5 for one side of the AC line. Maybe I made a mistake somewhere? I don’t remember it getting to the realm of too hot to touch but I’ve made so many errors on this tv it’s hard to imagine what state of mind I was in when I did it!
Even after about 5-7 minutes checking voltages you cannot touch it it’s hot but I feel the voltages are in the right area. If a mistake was made on the ballast then there should be several discrepancies in the voltages. So if later on I find that there is infact a problem with the ballast I’ll just put one together with resistors.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:36 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.