Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old 03-11-2023, 09:34 PM
Blast's Avatar
Blast Blast is offline
blast, blast...
 
Join Date: Jun 2007
Location: Kansas City
Posts: 237
Indeed!

Don't forgot the need for 'Chipper Check', the interface required to service many of those sets, not to mention having to use that system just to get the serial number of the set to make a warranty claim.

Throughout the nineties I worked in a major shop in Kansas City that was RCA/GE authorized and the guys there did a LOT of tuner shield/eeprom repairs.

I was the VCR/camcorder guy so I stayed away from much of that but I probably did a couple dozen of those tuner shield and associated eeprom repairs. Did you ever do the trick with the eeprom by unsoldering one pin? I don't remember how it was done.. But, if the eeprom wasn't too far gone you could still get the data off of it and not have to go through an entire time consuming alignment process.

I left consumer electronics repair in 2001 so the CTC203 was barely an introduction by the time I left. Doubt if I ever had my hands on one.

How Thomson didn't have close to 100% failure of that CTC17x through 18x chassis series would be beyond me.

Last edited by Blast; 03-11-2023 at 09:39 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:20 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.