Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #17  
Old 02-15-2023, 03:16 PM
JohnCT's Avatar
JohnCT JohnCT is offline
VideoKarma Member
 
Join Date: Jan 2020
Posts: 749
Quote:
Originally Posted by TrllVl90 View Post
I checked the filament voltage and got 2.2 (or 1.5 if I used the low-impedance setting). Both seem wildly incorrect. Would the retrace-cap value being low also drop the voktage? I know I got some cheap ones, but I'm not certain what the effects of high capacitance vs low capacitance are in the circuit.

Also I'm assuming I measured correctly. I measured across the two filament joints (in my case pins 9 &10).

Thanks in advance.

Edit: I also tested the voltage within a couple minutes of turning it on rather than waiting until the image became clearer. If that matters.

I don't think the tube would even light at 2.2V. The meter is on "AC" (~), correct?

Have you verified the meter? Try it on your wall plug to see if you are getting about 120VAC.

If the retrace cap is low in value, the HV and filament would be high.

I don't recall the pin numbers of the filaments, but they should read very low ohms (power off) across the filament pins (couple of ohms) if you are on the right pins.

Since sweep is regulated, the voltage will be the same hot or cold.

John
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:15 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.