Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 02-11-2023, 02:12 PM
Chris K Chris K is offline
VideoKarma Member
 
Join Date: Jun 2022
Posts: 1,534
Quote:
Originally Posted by dieseljeep View Post
You picked one of the harder sets to work on!
Did you know that the circuit board folds down to replace the tubes and make the other adjustments! Just remove the screws that hold it!
It's been over 50 years since I worked on one. I don't miss them!
BTW, the CRT grounding spring goes to the CRT mounting brackets and the control cluster.
PS, use the original factory service info, instead of Sams.
Thanks so much. Why didn’t I think of the rear circuit board!? I did hinge it down to do the recap. It is grounded to the chassis by the screws but I guess I could use clip leads for that. It will make the ion trap adjustment so much easier! I do have the sams. Couldn’t find the service info. I’m still not sure how to connect the spring wire to all of those points. It’s just a foot long spring with two hooks on each end.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:22 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.