![]() |
|
|
|
#1
|
||||
|
||||
|
If you always use a Variac, you don't need a resistor at all. Just put an AC voltmeter
on the 6.3 volt filament line and see what setting you need on the variac to get 6.3 volts when warmed up. |
|
#2
|
||||
|
||||
|
The most likely use is to ramp up voltage from a cold start.
On turn on the thermister starts at 120 ohms & quickly goes to near zero ohms. This limits the surge of the PS electrolytic caps charging up. Most sets use a @5.6 5Watt FUSE resistor for this. Test is to jump it & bring up on variac.This is NOT a fix but lets you check the set out BEFORE you chase & spend $$ on parts. Thats probably what you have ( without seeing schematic ). 73 Zeno ![]() LFOD ! |
|
#3
|
|||
|
|||
|
Quote:
Chris |
|
#4
|
||||
|
||||
|
...
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|