![]() |
|
|
|
#1
|
||||
|
||||
|
There was a cap, IIRC in the burst that killed the color
Boost usually feeds G-2 controls, audio & vert size. Looks bright enuf so probably OK. OK on HV probe, focus 5-6 KV apx & control near center of range for best focus Push & turn for VHF FT. There is an auto color switch on the back. Best to leave it off. It causes overall brownish color & was known as the "brownalater". Yuk ! Ticking, look inside the cage for arcing with room lights OFF. Also do a complete clean up from HV rect to the CRT. It may also be your focus problem. BTW the pix looks about normal brightness. It will NOT be as bright as a newer Chromacolor jug or newer in line sets. 73 Zeno ![]() LFOD ! |
|
#2
|
|||
|
|||
|
Quote:
Last edited by LukeSimon; 12-28-2022 at 02:47 PM. |
|
#3
|
||||
|
||||
|
Quote:
BTW, as to "ticking" around the HV system, I would be absolutely certain all connections carrying HV are as clean as you can get them; this should eliminate the noise. I personally cannot see why an HDTV would produce this sound anyway, since I don't believe there are voltages anywhere near high enough (in the kilovolt range) in a flat screen TV which could arc to ground and cause interference in the picture, let alone make ticking sounds of any kind.
__________________
Jeff, WB8NHV Collecting, restoring and enjoying vintage Zenith radios since 2002 Zenith. Gone, but not forgotten. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|